Thread: installing the r&d grips?
07-03-2011, 09:35 PM #1
installing the r&d grips?
do you need to cut the oem grip on the left side.
to make it fit with the trim system?
it would of helped if it would of come with instructions.
07-03-2011, 09:41 PM #2
Mine came with instructions but I decided to leave them off until the oem grips wear down. Im not home so I don't have the instructions on me but just email R&D and they will hook you up.
07-05-2011, 04:24 PM #3
hi you do have 2 cut off the oem grips just fitted some 2 mine. I used a blade just 2 strip off the left grip but it was still a pain in the ass good luck
07-05-2011, 10:08 PM #4
i remove the grip with the trim system in tact.
i assume the longer spacer is used on the trim handle.
and the grip that has been precut at the opening is for the trim side.
07-06-2011, 02:47 AM #5
sorry gordon forgot 2 say i fiited them on 2 a set of renthals on the riva steering set up so didn't use the spacers . but i did remove the grip with the trim intact hope this help's regards jay.....
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By kenshin89 in forum Sea Doo ClassifiedsReplies: 12Last Post: 01-26-2011, 09:10 AM
By blamed in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 06-01-2010, 10:24 PM
By floridarandy in forum Polaris Open DiscussionReplies: 1Last Post: 07-20-2009, 02:24 PM
By caliburst in forum Sea Doo ClassifiedsReplies: 3Last Post: 01-04-2009, 04:57 PM
By SantaCruz163 in forum Polaris ClassifiedsReplies: 2Last Post: 06-10-2008, 03:07 PM