07-05-2011, 10:32 AM #1
300x water pisser output very low.
I noticed my water pisser this weekend went to barely anything while at idle. Under throttle it would increase but still not as it should be. It's like 70% of the water was pinched-off to the pisser. No warning buzzers or lights for heat but it bothered me enough to tip the ski and make sure all was well. There was nothing blocking the intake and nothing inside it either. Any ideas on why this would happen? I am going to try and flush the cooling system today and see what happens.
07-05-2011, 10:36 AM #2
Read your owners manual, water flow is restricted so that it doesn't " over cool " the engine at idle and slow speeds.
07-05-2011, 11:36 AM #3
Thanks Chris. Read it before I ever rode it. I've owned skiis for about 25 years and I know what amount of water should be coming out of the pisser at different rpm's. This is definately not right.
07-05-2011, 05:09 PM #4
i dont think you have a problem all sounds right to me
07-05-2011, 05:45 PM #5
07-05-2011, 06:06 PM #6
07-05-2011, 06:23 PM #7
fixed must have had a bad stutter lol
07-05-2011, 06:50 PM #8
07-05-2011, 07:06 PM #9
- Join Date
- Jul 2006
There's a rubber hose on the other side off the pisser inside the hull; make sure it is not crimped. It's not likely, but it's not impossible.
07-07-2011, 02:56 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Glenn Briglio in forum Yamaha Open DiscussionReplies: 2Last Post: 04-16-2011, 01:40 PM
By Mowerpan in forum Yamaha PWC Performance (4-stroke)Replies: 3Last Post: 04-11-2011, 09:33 PM
By Gotta_Risk_It_#202 in forum Yamaha PWC Performance (4-stroke)Replies: 2Last Post: 12-14-2010, 08:45 PM
By otoss in forum 4-Tec PerformanceReplies: 3Last Post: 12-08-2010, 07:32 PM
By Deanrw3 in forum 2-Stroke PerformanceReplies: 8Last Post: 05-19-2009, 03:20 PM