Results 1 to 4 of 4
  1. #1

    Best method to clean ECU terminals

    I'm getting a code 7 indicating a problem with the ECT sensor. I have already replaced the ECT sensor and checked wiring from the ECU to the sensor connector. Upon examining the ECU terminals I do see some slight corrosion on some of them. The terminals are a good bit recessed in the connector. I was just wondering what the best way to clean these terminals is? Wire brush?


  2. #2
    JRINJAX's Avatar
    Join Date
    Oct 2007
    Location
    Jax, Florida
    Posts
    872
    +1
    1
    Use a stainless steel detail wire brush and then coat the teminals with silicone Di-electric grease.

  3. #3
    You could also try a clean like MG Chemicals Contact cleaner with Silicon, it works for electronics.

  4. #4
    xdrian's Avatar
    Join Date
    Nov 2008
    Location
    Brisbane Australia
    Posts
    898
    +1
    225
    disconect the battary first or you mite go bang

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Best method to break in a New Kawa Utra 300LX
    By need4speed in forum Kawasaki Open Discussion
    Replies: 24
    Last Post: 06-29-2011, 01:36 PM
  2. Best way to clean EGA sensor.
    By miker1 in forum Yamaha PWC Performance (4-stroke)
    Replies: 0
    Last Post: 05-26-2010, 02:07 AM
  3. Best way to clean IC?
    By T5Racing in forum 4-Tec Performance
    Replies: 1
    Last Post: 05-13-2009, 08:20 PM
  4. Best way to clean bolt threads ?
    By mrbtd in forum Shops, Tools and Tricks
    Replies: 6
    Last Post: 03-31-2009, 10:01 PM
  5. What is the best way to clean stock IC?
    By Pale Rider in forum 4-Tec Performance
    Replies: 13
    Last Post: 03-27-2007, 08:11 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •