Thread: Suck my wake pump extension kit
07-07-2011, 06:41 PM #1
Suck my wake pump extension kit
I have a complete pump extension kit that i bought from ct river guy on here and i never even tried it out, have all hardware all you will need is a riva adjustable VTS rod.. this kit has the pressure reliefs on it but you can just plug them for normal RXP use not RXPX asking $675 shipped in the USA
i also have a spare SMW extended driveshaft that is setup for the rad4 seal and is also lightened $60 shipped in the USA (might be good candidate for a conversion shaft)
just looking to clean out some stuff...
07-10-2011, 08:05 AM #2
PUMP EXT KIT SOLD!
shaft still available
07-10-2011, 09:51 PM #3
07-11-2011, 08:49 PM #4
When is a pump ext. Needed on a PX? What's the benefits? I know it's sold but just asking at this point.....thanks
07-12-2011, 07:30 AM #5
you dont need on a PX because of the larger intake grate area
07-12-2011, 08:21 AM #6
i put this on my px initially for pump relief. at the time I didnt like the idea of drilling plastic.. the extension is aluminum and was tapped for relief. A little while later guys were showing you could tap the plastic pump housing and it would hold up under pressure. so i went that route.
07-12-2011, 11:16 PM #7
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ULozer in forum 4-Tec PerformanceReplies: 15Last Post: 08-04-2009, 01:11 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 460Last Post: 11-07-2008, 08:01 PM
By ABBOTT in forum Videos & PicturesReplies: 14Last Post: 12-29-2005, 10:11 PM