Replaced my stator. Forgot to tighten water hose going to exhaust. Took it out, hose popped off and the exhaust got hot enough to set off an alert, Temp hit 107. Checked everything out at home, seemed good. Took out to test, started fine. Ran slowly out of no wake zone about a 1/4 mile. Slowly started picking up RPMs and then it died. Started back up fine, idled a minute, took off slowly, got up around 4k RPMs and same thing. Seemed to be ok around 2500 or less, went straight back to ramp. Could it be stuck in limp mode from getting hot the last time ??? Revs up on the trailer fine. Any suggestions ? I didn't have any alerts so I don't know what gives.