Results 1 to 6 of 6
  1. #1

    Join Date
    Jul 2009
    Location
    WA USA
    Posts
    148
    +1
    1

    How do you remove the 2 red wires off the starter relay?

    Hi, I have an 06 RXP and I'm in the middle of replacing my starter relay but I cannot remove the 2 red wires going on to the relay. Is there a special trick for getting these off? It looks like there is a special type of nut holding them on?

    Thanks!


  2. #2
    Got Boost? psycho rxp's Avatar
    Join Date
    Jul 2005
    Location
    Port St. Lucie, FL
    Posts
    5,445
    +1
    182
    10mm socket, just have to push pretty hard to get thru the rubber cover. The thinner the wall of the socket the better.

  3. #3
    iv just replaced mine it took me an hour and half wot a pain in the ass... i got the first nut off but while trying to push the socket onto the second one only went and dropped it in the ski right under the engine hahaha but yea the socket with fit its just a very tight fit

  4. #4
    MSRXP's Avatar
    Join Date
    Sep 2010
    Location
    Central MS
    Posts
    5,448
    +1
    7
    Pull the red silicone off and go that route. Put it back on when your done.

  5. #5

    Join Date
    Jul 2007
    Location
    Montgomery, AL
    Posts
    257
    +1
    1
    Putting a towel or two in the ski will prevent sockets, washers, and nuts from going into the black hole under the motor or other places you cannot reach. if this does happen just tilt the ski up and use a hose to wash them out.

  6. #6
    A smart admits!A wicked excuses!An idiot insists! mitsakosgt's Avatar
    Join Date
    Jun 2008
    Location
    GREECE ATHENS , NAXOS
    Posts
    2,693
    +1
    40
    I have machine a 10mm socket to fit the silicone cover!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How Do You Remove The Fuel Trap Door on a 2001 GP1200R??
    By stepjl in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 07-16-2015, 01:11 PM
  2. How do you remove the fairings on GPR?
    By Gus13letter in forum Yamaha How To & FAQs
    Replies: 7
    Last Post: 02-21-2011, 03:42 PM
  3. How do you remove the exhaust pipe on a 00 Virage?
    By chvscks319 in forum Polaris How To & FAQs
    Replies: 6
    Last Post: 07-24-2009, 10:58 AM
  4. How do you remove the STARTER on a 96 XP?
    By BartenderSmalley in forum Sea Doo Open Discussion
    Replies: 8
    Last Post: 08-04-2008, 02:27 PM
  5. how do you remove the opas
    By jonstephens in forum 4-Tec Performance
    Replies: 2
    Last Post: 07-14-2005, 06:07 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •