Thread: rxp 215 2006 year
07-14-2011, 03:05 PM #1
rxp 215 2006 year
hello people ive got a problem how do i check my magneto without the testing harness ???? ive done one test with ski running unplugged rectifier 3 yellow wires and tested each one with multi meter to ground and it showing 30+ is there another way ??
07-14-2011, 05:20 PM #2
will check with engine off and see if i get the 1.0 0.1 ??? also done the engine ground check to yellows and it hasent gone to earth ...
07-14-2011, 05:35 PM #3
Don't ground your lead when doing the voltage test!
You don't need that 5 pin deal..... do all three of these checks on the stator with a good multi-meter!
1. Check resistance between all 3 yellow stator wires, unplug stator and check 1-2, 1-3, 2-3
ohm readings should be between .1 - 1.0
2. With the engine running, stator unplugged test the 3 wires in the same three sequences mentioned above.
Set your meter for AC voltage, you should see 24 VAC on all three readings.
3. Set your meter to ohms, and attach the ground lead to a solid engine ground.
Check all three yellow wires for resistance to ground, there should be no resistance to ground.
07-16-2011, 04:53 AM #4
thanks tried new rectifier today dident work but i slipped off battery terminal and found one of the small earth leads was broke and only holding on by the shrink wrap all done problem solved thanks
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By keith neff in forum Sea Doo ClassifiedsReplies: 0Last Post: 06-28-2011, 05:30 PM
By bminchey in forum Sea Doo 4Tec SkisReplies: 3Last Post: 04-18-2011, 01:11 PM
By juan valdez in forum Sea Doo Open DiscussionReplies: 5Last Post: 04-05-2011, 05:38 PM
By Jlu in forum Sea Doo 4Tec SkisReplies: 0Last Post: 05-15-2010, 07:43 PM
By Summer in forum 4-Tec PerformanceReplies: 9Last Post: 01-29-2010, 08:43 PM