Results 1 to 3 of 3
  1. #1

    2000 xl1200 primer

    Does anyone have a picture of how the carbs look after the primer kit was installed? I would like to see a picture of the parts installed before I put one on myself. Also what is the best location to install the primming plunger? I beleave I have read where some people remove the choke handle and replace it with the primming plunger.

    Thanks


  2. #2

    Join Date
    Jun 2008
    Location
    Hillsborough, North Carolina
    Posts
    141
    Check out this thread over in the "FAQ & How To" sections...

    http://www.greenhulk.net/forums/show...r-pump-removal

    Hope this helps!

  3. #3

    Join Date
    Nov 2009
    Location
    NC
    Posts
    783
    +1
    29
    Remove factory choke plunger and set primer plunger in it's place, may have to drill out a bit.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Help -Need help on 2000 XL1200 Exhaust
    By bheston in forum Yamaha PWC Performance (2-stroke)
    Replies: 7
    Last Post: 04-05-2009, 07:07 PM
  2. 2000 XL1200 Ltd F/A adaptor size help
    By kaarona1 in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 03-13-2009, 04:34 PM
  3. Carb oil line clamps on a 2000 xl1200 ltd.
    By LakeDog in forum Yamaha PWC Performance (2-stroke)
    Replies: 17
    Last Post: 08-01-2008, 07:33 AM
  4. HELP! 2000 xl1200
    By jeremy3477 in forum Yamaha Open Discussion
    Replies: 7
    Last Post: 07-22-2008, 10:04 AM
  5. Bogging / Dying Problem with 2000 XL1200 Ltd
    By cigarzfan in forum Yamaha PWC Performance (2-stroke)
    Replies: 22
    Last Post: 06-12-2008, 11:12 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •