Ok so I pulled the jet pump,took the impeller and drive shaft out and my motor turns freely.I inspected the pump and intermediate shaft and all looks like new No water no wear marks ,no rust ,no play of any kind.The impeller has a rust mark on it as if it was rusted to the wear ring also the wear ring has a rust mark on it.The impeller was very hard to get out of the pump housing as if it was ceased to it.I don't understand how this could happen when I just had it running in my driveway last month but never the less it happened.I guess my question would be will a worn wear ring( I'm guessing that's what it's called ) cause the impeller to lock up? if so If i take a honing tool and clean it do you think that will work or should I look for a new pump housing? Thanks in advance to anyone that can help.