12-15-2006, 08:08 PM #1
think my waterbox is laid down too low?
check these pictures out and tell me what you think is wrong here:
12-15-2006, 09:16 PM #2
12-15-2006, 09:44 PM #3
12-15-2006, 11:06 PM #4
has anybody tried a 1200 waterbox in a 1300 setup?
12-16-2006, 03:00 AM #5
- Join Date
- Apr 2006
- Gore, New Zwaland
The service manual says to put a straight edge on the bulkhead lip, with the straightedge running rearward, and the highest part of the water box should be 0 to 5 mm above that. Yours looks good to me, do a measure up. REXA
12-16-2006, 06:38 AM #6
Thanks Rexa, I'll do that when I get home from work.
I am wondering 1200 waterbox would work or not. Whats the worst thing that can happen.
12-16-2006, 06:47 AM #7
My ski is a 2000 GP1200R that was changed to a 1300 EFI. The conversion went well, only a few minor mishaps that took a while to figure out. But here are some pictures of the ski.
12-16-2006, 07:06 AM #8
Good looking ski Shooter. I have heard (nothing to back it up) that a 1300 water box is better than a 1200 waterbox.
12-16-2006, 07:34 AM #9
12-16-2006, 11:36 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Mike's GPR in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 06-28-2009, 07:47 PM
By Mr_B in forum Sea Doo Open DiscussionReplies: 16Last Post: 07-10-2007, 10:42 PM
By RiverRat19405 in forum 2-Stroke PerformanceReplies: 0Last Post: 07-01-2007, 06:12 PM
By Robsauto2 in forum Kawasaki PWC Performance (4-stroke)Replies: 2Last Post: 05-14-2007, 10:07 AM
By 303RXP in forum 4-Tec PerformanceReplies: 0Last Post: 08-26-2006, 08:41 PM