Results 1 to 2 of 2
  1. #1

    Need seals for stub shaft

    Howdy gang!

    So my 1995 750 SL finally had some minor trouble. Got a terrible noise out of the pump when I revved the motor up. Tore it apart and it appears that it just spun a bearing on the stub shaft. I was able to get all the o-rings and bearings from my local machine shop, but we are at a loss of where to get the seals. I just need the two seals that go back back on the stub shaft. I wasn't able to cross the number, since it wasn't in my National seal book. Does anyone know where I could get these? Or a different number I can use? They look just like standard wheel seals, but the outer diameter wasn't listed in the book.

    Thanks!


  2. #2
    She likes the bike. But the ski gets her wet!!!! xlint89's Avatar
    Join Date
    Oct 2006
    Location
    Cleveland OH
    Posts
    17,329
    +1
    30

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. oil seal for output shaft?
    By spacecwboy in forum 4-Tec Performance
    Replies: 0
    Last Post: 08-10-2013, 06:39 PM
  2. FS - Parts Stub shaft, pump shaft, new bearing, new seals
    By Mighty Mouse in forum Polaris Classifieds
    Replies: 0
    Last Post: 01-04-2013, 01:04 PM
  3. Looking for a hardened stub shaft
    By hyoctane23 in forum Polaris Open Discussion
    Replies: 67
    Last Post: 07-27-2011, 07:40 PM
  4. need help my drive shaft is too short 28'' wath size i need for my gpr1200 01
    By gatinhonj29 in forum Yamaha PWC Performance (2-stroke)
    Replies: 5
    Last Post: 06-27-2011, 01:15 PM
  5. need help with drive shaft bushing and oil seals
    By kerino in forum Yamaha Old School Skis
    Replies: 4
    Last Post: 06-01-2011, 09:25 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •