Results 1 to 2 of 2
  1. #1

    After changing fuel pump will i need to readjust needle settings.

    I went the two line route. Is the different screw count per carb from the old single rail plumbing. Or the way the internals of each cylinder act.

    That sounds confusing. The factory settings hi speed needles are different for all three carbs. Did that have to do with old plumbing of rail or something different, hence if i change plumbing would that change as well.


  2. #2
    Buck3yeRideR's Avatar
    Join Date
    Jun 2011
    Location
    Brunswick/Marblehead, OH
    Posts
    108
    huh? Just swap n' go!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. What will I need to install a kawasaki 1100 engine into my 2003 STX900 hull???
    By Bala in forum Kawasaki PWC Performance (2-stroke)
    Replies: 12
    Last Post: 09-27-2011, 09:03 AM
  2. Replies: 1
    Last Post: 06-23-2011, 04:23 PM
  3. The last supercharger tool you will ever need to buy
    By Green Hulk in forum 4-Tec Performance
    Replies: 31
    Last Post: 10-09-2007, 10:17 AM
  4. What will I need to do?
    By boataddict in forum 4-Tec Performance
    Replies: 11
    Last Post: 01-02-2007, 12:11 PM
  5. Performance Fuel Pump,is it needed for stage2?
    By novice_4 in forum 4-Tec Performance
    Replies: 2
    Last Post: 05-03-2006, 10:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •