Results 1 to 2 of 2
  1. #1

    How to remove throttle/choke cable?

    I am in the process of rebuilding carbs on 1997 yamaha wave venture 760. Got stuck when it came to removing the throttle and choke cables. was gonna unscrew bolts on the bottom of cable but didn't want to mess anything up.

  2. #2

    Join Date
    Aug 2006
    Orange County, Ca
    You can remove either top or bottom bolt would be fine, when you put everything back just leave a little slack in the cable, but still need adjustment, for the throttle just lightly tighten the bolt and then squeeze the throttle and look at your carb plate see if it open fully, if not adjust, loosen and adjust top or bottom bolt and lightly tighten bolt, do this till the plate open fully, same goes for the choke plate but opposite, adjust and pull choke till the choke plate close fully and make sure when you open the choke, the plate open fully. You really cant go wrong.....

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How to remove Throttle body 2009 fx cruiser SHO?
    By GpaaH in forum Yamaha PWC Performance (4-stroke)
    Replies: 5
    Last Post: 08-04-2015, 10:04 AM
  2. how to remove the reverse cable lever to get room for ic removal and installation
    By peterj59 in forum Yamaha PWC Performance (4-stroke)
    Replies: 3
    Last Post: 11-18-2011, 08:34 PM
  3. 2008 Speedster 150 - How to remove throttle/shift levers?
    By TampaSpeedster in forum Sea Doo Sport Boats
    Replies: 4
    Last Post: 03-26-2010, 02:34 PM
  4. how to remove the choke to install primer
    By turk0004 in forum Polaris Open Discussion
    Replies: 3
    Last Post: 08-16-2009, 08:51 PM
  5. How to remove Throttle cable from handlebars?
    By camar0 in forum 4-Tec Performance
    Replies: 1
    Last Post: 09-22-2008, 11:20 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts