Results 1 to 8 of 8
  1. #1

    Help with Drive shaft tool

    Well I had my ceramic washers go throughout my motor and now currently getting ready to pull the motor and inspect the damage i did. I currently am thinking im going to need the front and rear oil pumps and possible the PTO guts and maybe housing. Some members also just told me that I can flush the bottom case out. Would anyone know on what to flush it out with? I dont know much about this driveshaft tool, but is it needed to get the motor out of the ski and if so does anyone know a good place to get it from? Any help would be much appreciated. Thank You.


  2. #2
    Moderator beerdart's Avatar
    Join Date
    Aug 2006
    Location
    CT
    Posts
    25,930
    +1
    1,407
    Where are you located?

  3. #3
    right outside of cleveland oh. Lake Erie

  4. #4
    Moderator beerdart's Avatar
    Join Date
    Aug 2006
    Location
    CT
    Posts
    25,930
    +1
    1,407
    The drive shaft can be removed without the tool. Removed the pump then drop a 14mm socket onto the prop then bolt the pump back on and slowly tighten the bolts till the the drive shaft pushes forward to expose the "C" clip then remove the clip. (Note if its rusted or stuck an few raps with a block of wood on the "Hat" should free it up" Dont not over tighten the pump bolts just enough to move the shaft 1/8-1/4"..

  5. #5
    ok thanks a lot... Somebody also told me that I need the tool to remove my PTO is that true?

  6. #6
    Moderator beerdart's Avatar
    Join Date
    Aug 2006
    Location
    CT
    Posts
    25,930
    +1
    1,407
    No.

  7. #7
    mbaseball3's Avatar
    Join Date
    Jun 2007
    Location
    stockton, ca
    Posts
    748
    +1
    21
    Pto is held on by 21 bolts

  8. #8
    ok thank you

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Need help removing drive shaft! Or borrow the Drive Shaft tool.
    By majundecid in forum 4-Tec Performance
    Replies: 29
    Last Post: 08-29-2013, 02:06 PM
  2. need help with drive shaft bushing and oil seals
    By kerino in forum Yamaha Old School Skis
    Replies: 4
    Last Post: 06-01-2011, 09:25 PM
  3. FS New Drive shaft tool, carbon ring and "C" clip
    By RXP-TOM in forum Sea Doo Classifieds
    Replies: 7
    Last Post: 10-12-2010, 09:39 PM
  4. New to PWC and to this forum. With Drive shaft questions
    By 2002Genesis in forum Polaris Open Discussion
    Replies: 14
    Last Post: 07-10-2010, 08:57 AM
  5. help please. drive shaft removal
    By mbaseball3 in forum 4-Tec Performance
    Replies: 9
    Last Post: 10-05-2009, 08:08 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •