08-01-2011, 08:20 AM #1
need service manual and tuto for removing driveshaft
I need a service manual and a tuto to install the driveshaft, can't find it on the how to section.
Thanks for the help
08-01-2011, 09:23 AM #2
first remove the C clip by sliding the floating ring back.
Then remove the pump and slide driveshaft out...
(if you dont have the driveshaft tool. Pull the pump and put a 10mm socket in between the driveshaft and impeller. Then, reinstall the pump. DO NOT CRANK THE 8MM BOLTS DOWN TOO TIGHT!!!
once that is done. You should be able to pull the c clip.... GL!
08-01-2011, 09:34 AM #3
hum sorry driveshaft already out lol....need to install it
08-01-2011, 11:26 AM #4
slide drive shaft through bellow boot/ carbon ring.
slide top hat on.
slide DS in PTO coupler.
Tap DS to make sure its seated...
Put pump back on.
Slide top hat/carbon ring/bellow boot towards the transom
put C clip back in...
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jvaski in forum 4-Tec PerformanceReplies: 0Last Post: 08-04-2011, 06:07 PM
By Miceleb in forum Kawasaki Open DiscussionReplies: 0Last Post: 03-28-2010, 11:53 AM
By gkecorp in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 04-02-2009, 08:22 PM
By HBILLYJET in forum Yamaha Old School SkisReplies: 2Last Post: 11-07-2008, 05:11 PM
By monsoonmadness in forum 4-Tec PerformanceReplies: 3Last Post: 06-20-2007, 07:17 PM