08-03-2011, 02:20 PM #1
need a temp switch for polaris msx 150!!!!
hi,any 1 got a temp switch for sale,new or used,
i use paypal,
its the single pin switch that fits in the exhaust manifold,
08-04-2011, 04:18 AM #2
you dont need this switch to maki/help it run, its a safty device, to limit revs when engine (exhaust) over heats.! my lead was broken on mine, possibly not connected for years, what makes you think you need a new one?
08-04-2011, 11:42 AM #3
mine has all melted sending my ski in limp mode,
i disconnected and it runs fine,,
whats your opinion,
08-04-2011, 11:43 AM #4
hows your ski doing,
have you sorted those cylinders?
08-04-2011, 12:00 PM #5
oh no simmy! another damn problem?!
Just leave that little sh1t disconnected lol
08-04-2011, 04:35 PM #6
i dont have a spare or anything. you could leave it disconnected. lust make sure the water feed to you exhaust is always pukka!
my skis all in bits. ready for new nikasil/piston/rods now!
so be getting wet again!
you had urs in the sea much?
08-04-2011, 05:06 PM #7
If, (and thats a big if) I ever buy a MSX 150 I wouldnt mess with the nikasil. I would have the cylinders sleeved and be done with it.
08-05-2011, 02:22 AM #8
08-05-2011, 11:19 AM #9
08-05-2011, 12:24 PM #10
hi spence,yeah whilst running on trailer for bowt 20 mins i could smell plastic,
then plenty of smoke from sender,
then temp light flashing,
had ski singing all week in wales,didnt miss a beat!!!
gona flush again this weekend with non-bio washing powder
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By spray&Splash2011 in forum MSX/MatrixReplies: 0Last Post: 08-06-2011, 09:25 PM
By simmy in forum Polaris Open DiscussionReplies: 18Last Post: 05-30-2011, 01:28 PM
By 2&4strokepolaristech in forum Polaris ClassifiedsReplies: 7Last Post: 03-18-2010, 07:12 AM
By freelancenovelist in forum MSX/MatrixReplies: 7Last Post: 09-18-2009, 06:26 PM
By H20Carver in forum Polaris Open DiscussionReplies: 2Last Post: 06-19-2007, 04:27 PM