Thread: Innovate LC 1 ?? Installation.
08-03-2011, 06:23 PM #1
Innovate LC 1 ?? Installation.
Now I need some Sirius help. I just got my innovate LC 1 kit and let me tell you that
I looks harder to install than I though. Can somebody walk me thru installing this, or where can I find instructions. Any help or tips will be very appreciated.
08-03-2011, 06:47 PM #2
Get a relay and use it for the install. It will ensure that your heater will be supplied with the correct constant voltage to not cause sensor failure. You can get them at auto zone.
87: Power to gauges (+)
87a: not used
30: Battery positive (+) (5 amp fused for load)
85: Battery negative (-)
86: Key on trigger wire (+) (purple wire to start button)
Follow the instructions in the manual. The most confusing part is wiring the led and push button into the mix. They need to be wired into the supplied wiring and then to the relay so that you can free air calibrate and also calibrate the heater. It is not too difficult. It will just take time.
08-10-2011, 06:55 PM #3
08-10-2011, 09:07 PM #4
Coming down from the gauge cluster there is a purple wire. Tap to that.
08-10-2011, 09:17 PM #5
08-10-2011, 10:39 PM #6
I just spread it all out on the bench and labeled each wire with a piece of masking tape where it goes. Like MSRXP says, it sounds worse than it is. Take your time and just follow the manufacturer directions. I don't have a relay in place yet, but definitely plan on installing one (at some point).
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mini73 in forum 4-Tec PerformanceReplies: 38Last Post: 08-05-2011, 06:35 AM
WTB Innovate LC-1By MSRXP in forum Sea Doo ClassifiedsReplies: 0Last Post: 05-20-2011, 08:14 AM
By maxadrenaline in forum Yamaha PWC Performance (4-stroke)Replies: 2Last Post: 12-05-2010, 08:15 PM
By Speed_Freak_039A in forum 4-Tec PerformanceReplies: 8Last Post: 05-04-2010, 01:38 PM
By aha in forum 4-Tec PerformanceReplies: 6Last Post: 04-14-2008, 07:45 PM