Thread: trim system question
12-20-2006, 10:39 AM #1
trim system question
on my 99 slx i am down to fixing the small thing now that its running. i noticed that the trim was not functioning. i did the test that the manuel describes (hooking a jumper wires straight to the motor) and the motor does function properly but it doesnt when u use the switch on the handle bar. now i did not have my mfd plugged in as i am trying to dry it out cause it foggy, would that make a differance or could the switch be faulty?
12-20-2006, 12:34 PM #2
Are you running the engine while making your test? You won't get 12+ volts to the trim system until the engine runs and the regulator switches the voltage on.
I think you can also just press the bilge switch and it should trip the power to the trim system, give it a try??
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By MD RACING in forum 4-Tec PerformanceReplies: 11Last Post: 07-02-2007, 09:06 PM
By born riding in forum Kawasaki PWC Performance (4-stroke)Replies: 2Last Post: 04-08-2007, 10:32 AM
By GPKiwi in forum Yamaha PWC Performance (2-stroke)Replies: 33Last Post: 10-20-2006, 10:24 PM
By cr1421 in forum Sea Doo Open DiscussionReplies: 2Last Post: 05-20-2006, 12:42 AM
By great lakes gpr 1200 in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 05-19-2006, 11:39 PM