Thread: map sensor signal wire?
08-10-2011, 07:13 PM #1
map sensor signal wire?
need to tap into the map sensor.. for the boost referance for my power commander..
need to know which wire is the signal out..i can probably figrure it out but if someone already knows it would be appreciated..
08-10-2011, 08:15 PM #2
If your looking over the intake mani side of the ski its the first wire while plugged into the sensor. Meaning that if your looking at the top of the connector from left to right its the first one on the left looking on top of it.
08-10-2011, 08:44 PM #3
so to the front of the ski..or the rear of the ski...simpler that way ..
08-10-2011, 08:50 PM #4
Rear. I know this for sure because i have my methanol controller taped into the sig wire on the map sensor and had to find out which one it was. Theres a 5 volt reference wire, a ground, and a variable voltage signal wire. The variable voltage sig wire is the one to the rear
08-10-2011, 08:52 PM #5
08-10-2011, 08:52 PM #6
sounds like the 1st one twards the rear of the ski to me...
08-10-2011, 09:14 PM #7
cool thanks saved me some time..i hate electrical..i allways do a good job at it because you have to ..but i hate it...let me bend cut and weld stuff..
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jdml in forum Yamaha PWC Performance (4-stroke)Replies: 2Last Post: 05-31-2011, 04:31 PM
By capricefrk013 in forum Sea Doo Open DiscussionReplies: 3Last Post: 05-15-2011, 06:11 PM
By flipsfzr in forum Yamaha PWC Performance (4-stroke)Replies: 2Last Post: 08-29-2010, 07:08 PM
By jetskibill9999 in forum 4-Tec PerformanceReplies: 8Last Post: 05-24-2010, 06:44 PM
By Fuhreal in forum 4-Tec PerformanceReplies: 0Last Post: 06-03-2007, 03:30 PM