Results 1 to 2 of 2
  1. #1

    1997 wave venture 1100

    Wave venture 1100 overheating.Ski has been sitting for a while and has been used in salt water. Had to clean carbs and rebuild. Back in water and took off well 30 -60 seconds later overheat indicator comes on. INtially it was peeing out the side then it stopped and then it started to some but didnt seem as much as at first. Took it back out and hooked hose up to flush and the stream out the side is stronger with the hose on it. Removed all lines going to exhaust elbow they all are clear. Proceeded to check barb fittings on exhaust itself. There is a bypass at the end near where it goes into the rear hull area one of these is clear and a short hose runs to the other one which is plugged. If I suck on it I get a tiny bit of air but if i blow I get nothing. IS this supposed to be plugged, I cant possobly imagine why but just throwing it out there.

  2. #2
    mudslanger's Avatar
    Join Date
    Jul 2010
    Huntsville Al
    Try to check the water inlet to make sure they are not clogged. dirt dobbers can get in the nozzle and stop up the holes in the pickup screen.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 1997 Yamaha Wave Venture 1100 carb, zert, and maintenance questions
    By ianshives in forum Yamaha PWC Performance (2-stroke)
    Replies: 4
    Last Post: 04-27-2017, 06:45 PM
  2. 1997 Wave Venture 1100 Spark Arrestor Screens/Performance?
    By trxxx250r in forum Yamaha PWC Performance (2-stroke)
    Replies: 6
    Last Post: 04-03-2015, 07:30 PM
  3. 1997 wave venture 1100 LOST HOOD.....HELP!!!!!!!!
    By george1100 in forum Yamaha Open Discussion
    Replies: 5
    Last Post: 07-07-2013, 01:56 PM
  4. 1997 wave venture 1100 display schematics
    By insaincivic00 in forum Yamaha PWC Performance (2-stroke)
    Replies: 0
    Last Post: 05-27-2013, 07:47 PM
  5. 1997 Wave Venture 1100
    By fastkaz in forum Yamaha Old School Skis
    Replies: 3
    Last Post: 03-29-2007, 07:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts