08-14-2011, 11:59 AM #1
Loose line under rear compartment of Sea-Doo RXT255-iS
I have a loose line in the back of my Sea-Doo and I can't figure out where it goes (if anywhere at all?).
Can someone help me to identify this and what it does exactly? I didn't take note if it was like this before, as I've only removed the rear (left) compartment once and didn't take a good look until a few days ago.
Thanks for all your help guys/gals!
08-14-2011, 02:31 PM #2
That is the bailer tube check valve system that has come loose. Look at the two drain fittings on the back of the ski, then look INSIDE the hull and you'll see one connected and the other disconnected (probably LEFT side missing). Simply re-attach and your good to go.
This system is what evacuates the water out of the hull while moving. My advice, install a bilge pump also!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum 4-Tec PerformanceReplies: 375Last Post: 10-14-2011, 09:02 PM
By TheEngineer in forum Sea Doo Open DiscussionReplies: 9Last Post: 07-29-2009, 07:21 PM
By Bigcat1 in forum Sea Doo ClassifiedsReplies: 0Last Post: 08-29-2008, 11:59 AM
By branix in forum Sea Doo Open DiscussionReplies: 2Last Post: 02-01-2008, 06:56 PM
By jagnew3 in forum Sea Doo Open DiscussionReplies: 7Last Post: 01-03-2007, 06:51 PM