08-15-2011, 07:13 AM #1
How to tell the difference between a 2 Rude and a Mini Rude?
Not sure if I have a mini Rude or a 2 Rude anybody know how to tell the difference?
08-15-2011, 07:16 AM #2
08-15-2011, 07:16 AM #3
137 vs 140 mm bro.
08-15-2011, 07:22 AM #4
08-15-2011, 07:50 AM #5
Well I don't have the spacer plate, so it must be a Rude 2. Does 13 lbs of boost at 8400 rpm sound right? Duke says I am down in power, he pitched a prop for me and rebuilt the charger. When I put the prop and charger on I could only get 7800 rpm with a 81 mm ring. I put a 83 mm ring on and got 8000-8100. Duke said it should have run 8500+ with the pitch he put in it, so I sent him back the prop, he re-pitched it and now I am at 8400-8450, he said it should be spinning more than that. I have checked cam timing, leak down test, compression test, Inncooler temps. Any ideas guys? Engine starts and runs great pulls pretty hard to, just trying to figure out why I am not running enough rpms.
08-15-2011, 01:34 PM #6
That's a 2Rude without the spacer. These are the boost numbers per the site..... Good luck Bro!
15.5 PSI boost at 8700 RPM
14.5 PSI boost at 8500 RPM
13.5 PSI boost at 8100 RPM
08-15-2011, 05:49 PM #7
well I measured the wheel its a 140mm. Now I get to find a small boost leak...
08-15-2011, 08:23 PM #8
- Join Date
- Jul 2011
- STL, LOTO
Pressure test, takes like 5 minutes.
08-15-2011, 09:12 PM #9
08-16-2011, 12:20 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mstennes in forum 4-Tec PerformanceReplies: 4Last Post: 08-17-2010, 10:35 AM
WTB MINI RUDEBy Lvnspeed in forum Sea Doo ClassifiedsReplies: 2Last Post: 01-22-2010, 10:09 PM
By murad in forum 4-Tec PerformanceReplies: 13Last Post: 01-14-2010, 07:11 PM
WTB mini rude..By Jaronk56 in forum Sea Doo ClassifiedsReplies: 0Last Post: 11-18-2009, 02:09 PM
By billyboy in forum 4-Tec PerformanceReplies: 18Last Post: 09-01-2009, 11:29 AM