Results 1 to 3 of 3
  1. #1

    Join Date
    Jun 2008
    Hamburg New Jersey

    cranck shaft question?

    I have a 2000 gp1200 with about 180 hours on it. I pulled the engine out to clean the hull, change the starter and bendix, and also put in a block off kit so I can run pre-mix. While I had the engine on the cherry picker the legs came out of the cherry picker, the engine fell to the ground and I put a small crack in the front of the case. I took the whole engine apart today and the crank looks good. My question is do I really need to get it checked out? If I do, I live in North West New Jersey is there any place close to me that I can just drop it off too?

  2. #2
    crashhard's Avatar
    Join Date
    Jul 2007
    Philly PA, Wildwood NJ, Indialantic FL
    No your crank is perfectly fine, dont worry about it. It was a fine running ski, it will be fine again just with new cases and seals.

  3. #3
    as long as the front cover was on, the crank should be fine. if the front cover was off and the crank hit the ground then you might want to have it checked for being true.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. inter shaft question
    By Hydrotherapy in forum Yamaha PWC Performance (2-stroke)
    Replies: 0
    Last Post: 11-16-2007, 10:46 AM
  2. crank shaft question
    By sea~smith in forum Polaris Open Discussion
    Replies: 1
    Last Post: 09-16-2007, 06:07 PM
  3. gtx shaft question
    By carl sagan in forum 4-Tec Performance
    Replies: 2
    Last Post: 06-02-2007, 05:57 AM
  4. Drive shaft question
    By edster67 in forum Polaris How To & FAQs
    Replies: 13
    Last Post: 05-19-2007, 11:56 PM
  5. aftermarket drive shaft question...
    By dewsy in forum 4-Tec Performance
    Replies: 4
    Last Post: 01-26-2006, 07:47 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts