Thread: My new 3" kanaflex air system.
08-31-2011, 06:59 PM #1
My new 3" kanaflex air system.
I just made an air system with 3" Kanaflex and a conical filter for my RXT. I was in the 7860 rpm range with the stock air box. Now I am back to around the 8040 rpm range
Not bad for under $70.
08-31-2011, 07:01 PM #2
08-31-2011, 07:16 PM #3
08-31-2011, 09:51 PM #4
- Join Date
- Apr 2011
- Kingston, Ontario, Canada
Did you wrap the pipe with insulating tape/foil??
08-31-2011, 11:42 PM #5
- Join Date
- Nov 2009
can u post a picture and a list of parts needed thanx
08-31-2011, 11:56 PM #6
Why not 4 inch?
09-01-2011, 04:34 AM #7
I cut a couple inch ring off the metal coupler, and inserted it into the end of the hose by the filter to give the rubber coupler something to clamp down on. The T-clamp came with a rubber ring inside the clamp. I used that ring inside the hose connecting on the SC inlet .then placed the clamp directly in line with the ring "over" the hose.
I don't plan on doing a lot of mods. if I did, than maybe I would have went 4"
09-01-2011, 08:39 AM #8
From everything I've read you don't want a filter with a fiber\paper element, but i bet that 3 inch was a hell of a lot easier to route than my 4 inch.
09-01-2011, 10:51 AM #9
09-01-2011, 11:51 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By blkturbo! in forum 4-Tec PerformanceReplies: 5Last Post: 04-10-2011, 10:16 PM
By gsxr800 in forum 4-Tec PerformanceReplies: 6Last Post: 03-01-2010, 10:59 PM
By JonnyRXT in forum Sea Doo ClassifiedsReplies: 2Last Post: 07-05-2009, 09:27 PM
By mstennes in forum 4-Tec PerformanceReplies: 44Last Post: 06-16-2009, 12:30 PM
By tottii in forum 4-Tec PerformanceReplies: 30Last Post: 03-15-2009, 01:59 PM