Thread: RPX Engine Block
09-03-2011, 03:49 PM #1
- Join Date
- Aug 2011
- oxford england
RPX Engine Block
Hi Folks, I need to get the broken fragments of a metal SC washer out of my engine block.
Is it possible to remove the bottom part of the engine block to expose the crankshaft, then clean the fragments out and replace it?
Do I need to take the timing chain off or anything else off before removeing the bottom part of the engine block?
09-04-2011, 12:11 AM #2
you need to pull the motor and split the cases to flush it properly. you should check your crank and rod bearings also get a new timing chain.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Gus13letter in forum 4-Tec PerformanceReplies: 7Last Post: 08-03-2011, 09:21 AM
By cdorcr911 in forum 4-Tec PerformanceReplies: 2Last Post: 03-26-2011, 06:11 PM
By joewharton2 in forum Sea Doo ClassifiedsReplies: 6Last Post: 10-25-2010, 12:20 PM
By beachbum0286 in forum 4-Tec PerformanceReplies: 75Last Post: 08-14-2008, 08:28 AM
By JAG in forum Videos & PicturesReplies: 0Last Post: 09-01-2006, 09:58 AM