12-27-2006, 12:40 PM #1
two part question..happy hoils guys
on removing my head 13r 05 to be skimmed i was having a close look and clean up when i noticed the spark plug mounting bosses on #3 were approx 1.5mm higher than #1 #2..assumed this at first to be due to comp being down on #3 due to heat ect.. then i cc the domes and found #3 still different..this is only again due to the heat problem but can some one clarify why spark plug higher in head and dome cc diffrent not just cc different..
2nd part question...
removed the cat tem sensor and blanking off does any one know the thread size..1/4 npt rings a bell but unsure..
once again happy new year to all
12-27-2006, 12:51 PM #2
Not sure on #1.
The thread is M10x1.25. I found an automotive oil plug worked to plug the hole.
12-27-2006, 01:18 PM #3
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Hydrotherapy in forum Yamaha PWC Performance (4-stroke)Replies: 3Last Post: 06-28-2010, 06:24 PM
By iam026tb4u in forum Yamaha Open DiscussionReplies: 3Last Post: 10-16-2007, 09:09 PM
By spyder3000gtvr4 in forum Yamaha PWC Performance (2-stroke)Replies: 9Last Post: 09-18-2006, 01:47 PM
By sabor in forum Sea Doo Open DiscussionReplies: 0Last Post: 08-16-2006, 01:38 PM
By 05RXPnoob in forum Sea Doo Open DiscussionReplies: 3Last Post: 05-05-2006, 08:37 AM