Thread: Used umi handlebar install
09-11-2011, 01:38 PM #1
Used umi handlebar install
I am going to install my UMI handlebars that I got from a part out,
can I use the dess post that came with them? or do I need to put on my dess post?
also it has the quick trim and start/stop wired up but there is an extra set of flat buttons that are wired to everything?
does that just extra?
09-11-2011, 07:41 PM #2
I just used my dess post and my start/stop switch and quick trim, It looked better that the mass of wires that came with the set up,
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By vspec1 in forum 4-Tec PerformanceReplies: 6Last Post: 08-15-2011, 11:15 AM
By bruinsrme in forum 4-Tec PerformanceReplies: 1Last Post: 05-28-2008, 12:25 PM
By mxl16 in forum 4-Tec PerformanceReplies: 9Last Post: 04-13-2008, 02:35 PM
By GeoRXT in forum 4-Tec PerformanceReplies: 7Last Post: 05-01-2007, 09:48 PM
By ccassone in forum Sea Doo Open DiscussionReplies: 18Last Post: 12-02-2005, 10:08 AM