Results 1 to 3 of 3
  1. #1

    corrosion resistant coatings for cast aluminum

    im looking for a corrosion resistant aluminum coating. ive media blasted all of my ride shoe, transom plate, pump extension, wear ring housing, pump stator, tail cone, trim ring, and nozzle. now just looking for a nice coating that is tougher than powdercoat to coat it all in so it doesn't corrode away. any ideas? i was looking at ....
    http://www.nicindustries.com/cerakote.php

    its the same coating used on keltec firearms.

    I can't seem to find any information on the coatings that mikuni uses on their throttle bodies or the coatings found on many oem yamaha parts.


  2. #2

    Join Date
    Aug 2006
    Location
    Orange County, Ca
    Posts
    275
    +1
    1
    Hard anodize it. I run my ski in saltwater 95 percent of the time I just hose it off really good and then use saltaway, I have no problem with corrosion...

  3. #3
    can't really hard anodize a yamaha transom plate, pump, ect. there is too much porosity. bruce from riva already found this out.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Looking for experienced welder (peice is cast aluminum)
    By Jolly Roger in forum Yamaha PWC Performance (2-stroke)
    Replies: 1
    Last Post: 07-12-2010, 06:15 PM
  2. heat resistant coating and custom pipes and tubes
    By born riding in forum Kawasaki PWC Performance (4-stroke)
    Replies: 0
    Last Post: 03-23-2009, 04:09 PM
  3. Coated Header and Aluminum Intake
    By novaprop67 in forum 4-Tec Performance
    Replies: 9
    Last Post: 06-19-2008, 06:59 PM
  4. Need resistence reading for overheat sensor GPR1200
    By water worx in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 05-18-2007, 01:03 PM
  5. b.o.v block off for riva aluminum piping
    By excess in forum 4-Tec Performance
    Replies: 10
    Last Post: 11-27-2006, 04:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •