Results 1 to 2 of 2
  1. #1

    STX15 Jet pump impeller stuck on driveshaft

    Have worked on this thing for about 8 hours and still can't get the pump out of the jetski. The impeller seems to be stuck to the driveshaft, I've tried heating it with propane, pulling it with my truck while the ski is on the trailer and still not luck. All of the bolts holding the pump housing in are removed including the ride plate.

    I can get the pump back far enough to pop the rubber ring out and almost away from the engine coupler, but that's as far as it goes. The impeller will not rotate more than 15-20 degrees, I've taken the plugs out of the engine. I did get the cone out of the back of the pump bearing housing, pulled the seal off the bearing and it looks fine.

    Do I have to cut the driveshaft? is this a common problem?


  2. #2
    steve45's Avatar
    Join Date
    Feb 2008
    Location
    Texas
    Posts
    5,008
    +1
    282
    Can you put a slide hammer on it? That's what I used on my Ultra, worked fine.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Jet pump impeller stuck, bearing removal
    By Porkchop_ina_Can in forum Polaris Open Discussion
    Replies: 4
    Last Post: 06-08-2013, 08:22 PM
  2. impeller stuck on driveshaft
    By squared in forum Kawasaki Open Discussion
    Replies: 0
    Last Post: 11-22-2011, 11:33 AM
  3. jet pump impeller Question pic included
    By rdizz81 in forum Polaris Open Discussion
    Replies: 17
    Last Post: 05-22-2010, 03:27 PM
  4. Replies: 1
    Last Post: 06-30-2008, 10:15 PM
  5. Jet pump bearing grease on rxp
    By dre23 in forum 4-Tec Performance
    Replies: 12
    Last Post: 12-11-2006, 11:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •