Results 1 to 2 of 2
  1. #1

    zxi elect box replacement plug cord grip

    Anybody know if it's like a bulk head fitting or does it thread in. I have one sealed with silicone. If Threaded ? Is it pipe thread ? Gonna finish getting some play time before water gets hard or when I mean I wuss out on temps before I tear into it.

  2. #2
    steve45's Avatar
    Join Date
    Feb 2008
    The white nylon part has a straight thread. There is a rubber seal, than the black cap goes on the outside of that.

    You can remove the pins from the connector by using a pin to unlock them, then push them out of the plug. Make sure you make a diagram first so you can get all the pins back in the right places.

    I put a dab of grease on the seal to make it go back together easier.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Another replacement grip with QSTS thread!
    By sigibbons in forum Yamaha PWC Performance (4-stroke)
    Replies: 10
    Last Post: 08-04-2009, 04:24 AM
  2. Need a 1200 elect box gasket
    By WFO in forum Yamaha Classifieds
    Replies: 3
    Last Post: 04-05-2009, 09:37 AM
  3. Spark Plug Wire Replacement 95' XP
    By VetteTech81 in forum 2-Stroke Performance
    Replies: 8
    Last Post: 11-01-2007, 11:54 PM
  4. Plug replacement - what type
    By fairlanex in forum Kawasaki PWC Performance (4-stroke)
    Replies: 22
    Last Post: 09-03-2007, 08:24 AM
  5. Drive Shaft Plug Replacement
    By 1FastTrespiper in forum Sea Doo Open Discussion
    Replies: 6
    Last Post: 07-17-2006, 10:47 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts