Results 1 to 3 of 3
  1. #1

    1988 JS440 shaft and impeller removal

    The seal where the impeller shaft goes through the hull is leaking so I need to replace it. I started disassembling the pump and I dont know how to get the impeller off. I also dont know if the engine needs to be removed to take the shaft out completely? Thanks


  2. #2
    800AMSOIL4U's Avatar
    Join Date
    Aug 2006
    Location
    Morgan Hill, CA
    Posts
    5,024
    +1
    132
    Yes you need the tool to go on the back of the impeller and also have to pull the engine to get the shaft out. You can put a large screw driver through the shaft to hold it. Where are you located?

  3. #3
    So the impeller is threaded? What does the tool look like? I've found a few on the Internet but none of them look like they would work. I'm in Gresham oregon

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. RIVA Supercharger Shaft and Impeller Install - Overview
    By Green Hulk in forum Yamaha PWC Performance (4-stroke)
    Replies: 32
    Last Post: 12-17-2009, 02:06 PM
  2. Stripped Drive Shaft and Impeller
    By Overcenter76 in forum 4-Tec Performance
    Replies: 10
    Last Post: 11-01-2009, 12:54 PM
  3. Replace shaft and impeller 97 SLT 700
    By bradleyj00 in forum Polaris How To & FAQs
    Replies: 3
    Last Post: 01-12-2009, 08:41 PM
  4. WTB '99 GP800 Drive shaft AND Impeller ASAP!
    By ProXR 440 in forum Yamaha Classifieds
    Replies: 4
    Last Post: 07-16-2008, 05:47 PM
  5. Will Virage drive shafts and impellers work on 750 hull from 94?
    By JGringo in forum Polaris Open Discussion
    Replies: 14
    Last Post: 08-18-2007, 12:47 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •