10-11-2011, 06:58 PM #1
ET 140 Rude replacement check spacer.
I was checking over a few things today and noticed my charger was pressing on my pto bellow right where the outter ridge of the bearing is on the driveshaft. . It was leaving indentations on the pto bellow. I'm going to grind back the spacer that was machined slightly off can't be good for the bearing or alignment of shaft. .. i'm just curious though, this charger isn't new by any means..... I bought from a fellow member.... and just rebuilt it about 15 hrs ago. I wanted to let some of the other guys running this same charger just to check theres. Love the charger just giving heads up.
In the pick you can see the spacer isn't following the charger casing. (simple fix)
10-11-2011, 07:47 PM #2
10-11-2011, 07:50 PM #3
ive never noticed it when putting it on.. or taking it off.. It could just be a miscut on my spacer just giving heads up. It definatly pushed against pto bellow/bearing pretty firmly!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Glade Rider in forum 4-Tec PerformanceReplies: 111Last Post: 06-27-2011, 11:14 AM
By andy95'slx780 in forum Yamaha PWC Performance (4-stroke)Replies: 0Last Post: 06-02-2011, 07:07 PM
By rick xp in forum Sea Doo ClassifiedsReplies: 1Last Post: 03-27-2010, 07:08 PM
By ddleigh in forum Yamaha How To & FAQsReplies: 1Last Post: 10-06-2008, 12:30 PM
By theedawgpound in forum Polaris How To & FAQsReplies: 3Last Post: 08-09-2007, 10:53 PM