Results 1 to 2 of 2

Thread: Reuseing Parts

  1. #1

    Reuseing Parts

    I'm replacing my crankshaft in my 1100 stx di motor. Can I reuse the small end bearing and wrist pin? I only have about an hour or two on the engine.Im also installing new OEM pistons as well.


  2. #2
    I like Boobs. wetwolf's Avatar
    Join Date
    Nov 2005
    The NSA know's that I'm in Spokane, WA
    As long as there are no signs of wear, it is fine to reuse pins and bearings. But you should install the pin and bearing into the rod and spin it to make sure it rotates freely, especially if you are doing a crank due to hydrolock. Pistons are OK as well as long as the piston to cylinder clearance is within spec. Don't reuse circlips if they have been removed, if you only took one out to get the pistons off, it's OK to leave the the one in the piston.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. What are you guys doing with stock parts off your ski?????
    By Jrsrxp in forum 4-Tec Performance
    Replies: 15
    Last Post: 09-30-2005, 05:57 AM
  2. Got new parts for my RXP???
    By muskadoo in forum 4-Tec Performance
    Replies: 10
    Last Post: 05-30-2005, 10:57 AM
  3. R.O.C.X. Discount on parts?
    By noose in forum 4-Tec Performance
    Replies: 6
    Last Post: 05-23-2005, 03:46 PM
  4. New Parts Arriving
    By 1FastTrespiper in forum 4-Tec Performance
    Replies: 14
    Last Post: 05-22-2005, 08:51 PM
  5. Cole Camp, one of the neatest parts of Lake of The Ozarks...
    By theantiRXP in forum Sea Doo Open Discussion
    Replies: 5
    Last Post: 05-17-2005, 03:21 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts