10-30-2011, 03:11 PM #1
NEEDED: ExMani bolts, square injector clips, set button, 83 ring
DISREGARD...GOT EVERYTHING. THANKS GUYS.
I need the following. Let me know what you have and how you can help.
1) x3 square metal fuel injector clips (holds injector to fuel rail)
3) x2 bung plugs (plug only, not the entire bung)
7) x1 set button
x1 83mm nozzle ring
Last edited by jpeconsult; 10-31-2011 at 04:33 PM.
10-30-2011, 04:33 PM #2
I have a lower hour bellow and carbon seal. I also think I have the mode set buttons..
Pm me if you need them..
10-30-2011, 05:04 PM #3
10-30-2011, 09:50 PM #4
Got the carbon seal, bellows and mode button. Thanks Brandon.
10-31-2011, 02:03 AM #5
I have the exhaust manifold fittings. What do you need. I have them all. The 45 degree is on the bottom. The smaller ones that go towards the rear are 90 degree. Look at pic below. I'll send out tomorrow what you need.
I also have plugs. You need 3? What about an oil filter?
Stock water box and stock grate too.
10-31-2011, 02:04 AM #6
I'll also send you some SS manifold bolts. I have some new ones laying around here somewhere.
They are M6x45 if you can make it to lowes and get SS ones. I replaced mine last month before MB. I refused to pay the 3.49 each the stealer wanted.
10-31-2011, 02:09 AM #7
10-31-2011, 12:24 PM #8
10-31-2011, 12:34 PM #9
just shipped the bellow, carbon seal and the mode button....
10-31-2011, 12:39 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jdmctr in forum 4-Tec PerformanceReplies: 107Last Post: 11-01-2011, 08:47 PM
By rmk82nd in forum 4-Tec PerformanceReplies: 5Last Post: 06-04-2011, 10:05 AM
By RXP rider in forum 4-Tec PerformanceReplies: 12Last Post: 03-29-2011, 08:27 PM
By Pale Rider in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 10-05-2009, 04:45 PM
By mrbtd in forum Sea Doo ClassifiedsReplies: 3Last Post: 07-20-2009, 04:16 PM