Thread: Yamaha YPVS
10-31-2011, 06:25 AM #1
Hello guys, i am currently in the process of rebuilding the motor and putting it back together. I have put the powervalves back on and connected the servo wires back onto the wheel. I was wondering when i start the motor will these automaticly adjust? or do i have to do it manually?
10-31-2011, 09:16 PM #2
You need to manually adjust it. See instructions below. When the engine is briefly started and stopped, they will cycle. You need to make sure they open/close properly.
10-31-2011, 10:25 PM #3
Thank you very much! i couldnt find this in the service manual i have.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mudslanger in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 06-24-2011, 03:47 PM
By grubber in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 04-08-2011, 06:59 PM
By blown-03 in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 02-23-2011, 11:27 AM
By extreemthrottle in forum Yamaha ClassifiedsReplies: 0Last Post: 05-06-2010, 08:57 PM
By jchale in forum Yamaha Old School SkisReplies: 2Last Post: 06-10-2009, 09:14 AM