Results 1 to 4 of 4
  1. #1
    Lock and Load tron's Avatar
    Join Date
    Jun 2007
    Location
    LAX, WI
    Posts
    259
    +1
    1

    Pump Wedge thickness?

    Looking to cut a pump wedge out on the waterjet and then have the 2 degrees faced off but I'm wondering what the material thickness is on the "thicker" side / bottom side?


  2. #2
    h2jim's Avatar
    Join Date
    Nov 2008
    Location
    Ontario Canada
    Posts
    2,063
    +1
    61
    Just measured one quickly and it's 6mm.

  3. #3
    h2jim's Avatar
    Join Date
    Nov 2008
    Location
    Ontario Canada
    Posts
    2,063
    +1
    61
    Making it thicker wouldn't hurt. Just keep the 2'.

  4. #4
    Lock and Load tron's Avatar
    Join Date
    Jun 2007
    Location
    LAX, WI
    Posts
    259
    +1
    1
    Perfect....Thanks!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Pump wedge discovery / question.
    By KEN G in forum 4-Tec Performance
    Replies: 3
    Last Post: 09-17-2005, 12:08 PM
  2. Pump wedge
    By Angelse68cal in forum 4-Tec Performance
    Replies: 1
    Last Post: 08-25-2005, 07:58 PM
  3. 2 degree pump wedge??
    By RXPNJ in forum 4-Tec Performance
    Replies: 7
    Last Post: 06-30-2005, 10:07 PM
  4. RXT w/ Pump wedge GPS RESULTS.... THE MYTH behind it all
    By Shibby1485 in forum 4-Tec Performance
    Replies: 14
    Last Post: 06-13-2005, 05:40 PM
  5. PUMP WEDGE
    By RXPNJ in forum 4-Tec Performance
    Replies: 8
    Last Post: 05-10-2005, 09:47 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •