11-14-2011, 07:36 PM #1
External Intercooler install on 06 rxp water routing question
I have my External Intercooler that came from a X ski all in and ready to hook everything up,
I have been reading the intstall instructions on several different models like the Gen 2 power cooler kit, the X cooler relocaton kit etc..
The water routing seems easiest to do, for an 06 year is the instructions from the Gen 2 power cooler kit,
Am I reading this correctly?
It shows the water inlet hose from the pump goes to the inlet side of the EX IC, (with no T fitting), then the outlet from the EX IC goes up front to the Exhaust manifold, and the Exhaust little cooling hoses stay the same, on top of the J pipe etc..
but then it shows if you do the intall on the 08 or newer you have to use that T fitting on the water inlet from the pump so some goes to the Exhaust manifold and some goes to the EX IC? I do not use the T correct?
The 1/4" little top nipple on the side of the EX IC is a water outlet tube anywhere out correct?
I was thinking of using a small pisser outlet so I could monitor the water output, like the tripple piped Polais I have with 3 pissers overboard
11-14-2011, 07:43 PM #2
11-14-2011, 07:52 PM #3
I have a inline filter, I was just wanting to know which water routing was best?
the Ex Ic came with a bunch of hoses that came from the donor ski, including the T piece, but I think it came from an 08 ski,
11-14-2011, 07:57 PM #4
11-14-2011, 08:03 PM #5
The 08 has different exhaust setup than your 06 so the water routings are slightly different. Stick with the one without the T you will be fine.!
11-14-2011, 08:16 PM #6
I would T the incoming water with the X cooler, they can't handle the high pressure .
11-14-2011, 08:20 PM #7
11-14-2011, 08:23 PM #8
If I use the T and go one to the intercooler and one to the front of the exhaust, then I don't have a place for the outlet to go? my J pipe has a different set up than the 08 x ski?
will that 1/4" nipple let pressure out thru the pisser?
11-14-2011, 08:30 PM #9
11-14-2011, 08:47 PM #10
will the intercooler get enough water to keep it cool?
I am going to use a strainer does that cut down on flow?
also I can drill out the bleeder 1/4" nipple,
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By thompsdw in forum 4-Tec PerformanceReplies: 12Last Post: 09-12-2011, 06:52 PM
By skigolfnut in forum 4-Tec PerformanceReplies: 5Last Post: 07-18-2011, 09:38 PM
By jdlrocu in forum 4-Tec PerformanceReplies: 10Last Post: 07-14-2011, 12:11 AM
By skigolfnut in forum Sea Doo ClassifiedsReplies: 4Last Post: 07-05-2011, 06:53 PM
By turbojamie in forum 4-Tec PerformanceReplies: 2Last Post: 08-26-2008, 08:39 AM