Results 1 to 6 of 6
  1. #1
    skigolfnut's Avatar
    Join Date
    Jun 2009
    Location
    League City TX
    Posts
    1,979
    +1
    33

    Pulling 785 engine, do I have to remove the carbs?

    I am finally pulling the engine in my wrecked limited race ski,
    I had 3 broken motor mounts, it is ready to come out,
    will it come out the seat hole without the carbs off?
    thanks,


  2. #2

    Join Date
    Aug 2006
    Location
    Homer Glen Il.
    Posts
    8,702
    +1
    109
    if i remember right you can leave the carbs on if you pull the head pipes or vice versa

  3. #3
    Tony's Avatar
    Join Date
    May 2007
    Location
    North Carolina
    Posts
    1,760
    +1
    38
    I didn't have carbs on but it shouldn't matter


  4. #4
    skigolfnut's Avatar
    Join Date
    Jun 2009
    Location
    League City TX
    Posts
    1,979
    +1
    33
    Yea its out,
    I pulled the carbs and the last mag exhaust piece off, and my brother and I lifted it out by hand, it wasen't too heavy, a good way to work off some of the pecan pie with extra whipped cream I had,
    I am going to have to re-use one of the tripple pipe front mounts that is glued in,
    any ideas on how to remove them?
    thanks,

  5. #5

    Join Date
    Aug 2006
    Location
    Homer Glen Il.
    Posts
    8,702
    +1
    109
    warm it up around it with a heat gun and then give it a tap with a hammer

  6. #6
    skigolfnut's Avatar
    Join Date
    Jun 2009
    Location
    League City TX
    Posts
    1,979
    +1
    33
    thanks,
    happy thanksgiving and keep that matrix running good,

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Do I have to remove the ride plate to change the intake grate?
    By Bamaha1 in forum Yamaha PWC Performance (4-stroke)
    Replies: 1
    Last Post: 07-11-2013, 07:00 PM
  2. Do I need to remove the engine to inpect hull?
    By Dazza169 in forum Yamaha Open Discussion
    Replies: 1
    Last Post: 01-18-2009, 10:35 AM
  3. Do I have to remove the exhaust chamber?
    By Jetscreamer in forum Yamaha PWC Performance (2-stroke)
    Replies: 1
    Last Post: 07-11-2008, 12:25 PM
  4. Will I have to remove the waterbox????
    By GeoRXT in forum 4-Tec Performance
    Replies: 25
    Last Post: 09-13-2006, 07:09 PM
  5. Instaling my BOV do I have to use the middle notch????
    By Jrsrxp in forum 4-Tec Performance
    Replies: 11
    Last Post: 07-22-2005, 07:32 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •