Thread: Intermediate housing
11-29-2011, 09:03 PM #1
Where is the greasing nipple on a 2012 FZR?
11-29-2011, 10:13 PM #2
usually next to the flush hose port
11-29-2011, 10:25 PM #3
11-29-2011, 10:37 PM #4
11-29-2011, 10:52 PM #5
- Join Date
- May 2009
- Nashville, Tn
Already got a 2012? Didn't think they were being released until spring.
11-29-2011, 10:56 PM #6
Got 12 hours on it, when I did the 10 hour service couldn't find the greasing nipple
11-29-2011, 11:37 PM #7
I've been trying to help Mike out via PM, and I suggested he posted for everyone to see. While I don't have a 2012 ski or access to a 2012 service manual, I would assume yamaha just got rid of the long hose and has the grease nipple a lot closer to the intermediate housing.
11-29-2011, 11:46 PM #8
If you can't find the hose coming off just pull the coupler cover. I think it's only one bolt holding it on.
11-30-2011, 06:26 AM #9
I think it's only one bolt holding it on.
Unless they've changed the design for 2012, it's a single bolt and two rubber press-to-fit connectors. Not surprised the hose has been eliminated. It was hard to judge when you actually got grease to the bearing vs just filling the hose.
11-30-2011, 07:38 AM #10
Now is hard to see the housing the electrical box is on the way
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By hitman in forum Yamaha PWC Performance (4-stroke)Replies: 5Last Post: 04-26-2011, 03:50 PM
By rbi in forum Yamaha Open DiscussionReplies: 0Last Post: 06-29-2010, 04:59 PM
By tubetent in forum Yamaha How To & FAQsReplies: 6Last Post: 02-25-2009, 10:29 AM
By JKR1300 in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 10-30-2006, 05:38 PM