12-10-2011, 11:54 PM #1
Question about Riva IC and a boost guage..
I never looked too far in to it yet but from what I can see it doesnt appear that the sender is going to fit on the front manifold boss with a Riva IC. Am I correct in assuming this? I ask because the instructions (power cooler) want you to cut the front boss off of the manifold which Im guessing is due to space being needed.
If I'm correct then is there anyway around this with the Riva IC?
Are the same issues present with the R&D unit?
Any major disadvantages between the two?
Thx in advance!
12-11-2011, 12:46 AM #2
12-11-2011, 12:57 AM #3
Yeah I though about that but wasnt sure about grinding the boss down. I already have a dynotube sensor installed there and wasnt sure if I'm able to plug it after taking the boss off.
12-11-2011, 02:01 PM #4
12-11-2011, 10:10 PM #5
12-13-2011, 08:07 PM #6
- Join Date
- Sep 2008
- NE Ohio
12-13-2011, 08:20 PM #7
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 08rxp in forum 4-Tec PerformanceReplies: 34Last Post: 10-10-2011, 11:56 PM
By castaicsportsgarage in forum 4-Tec PerformanceReplies: 5Last Post: 07-12-2010, 05:20 PM
By CarFanatic in forum 4-Tec PerformanceReplies: 16Last Post: 05-19-2007, 03:08 AM
By SpeedStang95 in forum Sea Doo Open DiscussionReplies: 9Last Post: 06-04-2006, 01:58 PM
By INDY27 in forum 4-Tec PerformanceReplies: 29Last Post: 10-25-2005, 08:23 AM