12-26-2011, 10:49 AM #1
Yamaha GP1300r gauge bench test power up
I have looked over the service manual and searched for a few days, but can't seem to find how to do a bench test for hours. Know it works, just don't know the hours. Any help, link or direction would be great.
12-26-2011, 11:06 AM #2
l Supply DC 12 voltage to the natural
color six-pin connector (+: red, –:
black) with a battery.
l Disconnect the green two-pin connector
(white/blue and black leads).
l Connect the white/blue and black terminals
with a jumper lead 1.
l Connect the green and red terminals
with a jumper lead 2.
If the jumper lead is installed for more
than 30 seconds, the display will automatically
12-26-2011, 01:48 PM #3
Thanks for the reply. The 1300r gauge has no 6 pin connector. I believe the 1200 does.
12-28-2011, 08:27 PM #4
lee ,lee its on the service manual.read it again.i believe i send you a copy right? hahaha.
01-16-2012, 05:51 PM #5
where is this in the service manual? page number? or just how do you do it on a 1300?
01-18-2012, 10:24 AM #6
01-21-2012, 02:56 PM #7
I figured it out. Use the connector below and hook up - to the black and + to the red. That's it.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Mark-UK in forum Polaris Open DiscussionReplies: 14Last Post: 05-29-2016, 07:44 AM
FS - Parts Yamaha GP1300r gaugeBy leejax01 in forum Yamaha ClassifiedsReplies: 2Last Post: 12-30-2011, 08:47 PM
By rangermtb5 in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 01-13-2011, 09:08 PM
By yacser1 in forum 2-Stroke PerformanceReplies: 0Last Post: 09-05-2010, 07:06 PM
By Goliath in forum Yamaha Open DiscussionReplies: 7Last Post: 07-24-2009, 10:09 PM