Results 1 to 8 of 8
  1. #1

    Mcmaster Carr part number for Ada 951 dome o rings

    Does anyone have a part number for mcmaster Carr for Ada 951 compression o ring on the dome
    Thanks


  2. #2
    I had to buy a Roll of Silicon O-Ring matl. (orange) from McMaster and make my own for the ADA Domes.
    They didn't have the correct combination cross section diameter and O.D. I needed at the time which
    was over 7 years ago.

    I still have several feet of that O-ring matl. left somewhere in the garage if you need it.
    I wont be using it anymore since my 2-Stroke days are over.

  3. #3
    Would you happen to remember the diameter of that o ring?I'm building a yamaha with seadoo pistons and am trying to find out if the o ring will sit on the flange of the sleeve before in order them

  4. #4
    Goose,

    Your talking about the O-ring that sets in the Groove around the Edge of the ADA Dome and seals against the top edge of the Cylinder / Sleeve area on the Jug -- correct ?

  5. #5
    m schmidt's Avatar
    Join Date
    Mar 2007
    Location
    East, Tn.
    Posts
    235
    +1
    2
    Quote Originally Posted by goose View Post
    Would you happen to remember the diameter of that o ring?I'm building a yamaha with seadoo pistons and am trying to find out if the o ring will sit on the flange of the sleeve before in order them
    A yamaha with sea-doo pistons tell us more?

  6. #6
    Yes David that's what I'm looking for.
    Im building a freestyle engine it's s r&d/lamey. It had bigger sleeves put in but the flange on the top doesn't look wide enough to fit an Ada dome but not sure. 68mm stroke,89mm bore
    Thanks for the replys

  7. #7
    no one have a ada 951 dome laying around they can take a measurement? called ada they were too lazy to get calipers out and measure

  8. #8
    .065-----

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Need Help with part Number for 2 Stroke
    By 1 FAST VE in forum 2-Stroke Performance
    Replies: 6
    Last Post: 05-22-2008, 10:31 AM
  2. Part numbers for 05 pump swap?
    By Yellow93 in forum Yamaha PWC Performance (2-stroke)
    Replies: 6
    Last Post: 09-07-2007, 09:32 AM
  3. part numbers for bearings and seal in the pump housing
    By gvnitup in forum Polaris How To & FAQs
    Replies: 2
    Last Post: 05-03-2007, 08:25 AM
  4. Part Number for Service Manual.
    By Hydrotoys in forum Kawasaki PWC Performance (4-stroke)
    Replies: 18
    Last Post: 02-05-2007, 10:03 PM
  5. Part Number for 4 inch K&D Filter
    By sr71bb in forum 4-Tec Performance
    Replies: 24
    Last Post: 09-01-2006, 12:31 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •