Results 1 to 2 of 2
  1. #1

    Join Date
    Jun 2008
    Location
    Hillsborough, North Carolina
    Posts
    141

    How much oil & where do I add it when reassembling a GP 1200R engine?

    Probably a stupid question but I figure lubing everything to be obvious. Are there any extra (qty?) amounts of 2 stroke oil I should dump in the crankcase area or pv areas? What about "waterproof" greasing in specific areas?

    Just trying to be thorough.

    Thanks Y'all!


  2. #2
    Happily Self-Employed WFO's Avatar
    Join Date
    Nov 2005
    Location
    Houston, Texas
    Posts
    12,801
    +1
    450
    crankcase has holes next to the bearings in the cases... use a cooking injection needle and shoot some 2 stroke oil in there... also shoot some oil on the rods in the cutouts for the big end bearings... dip the rod bearings in 2 stroke oil before assembly, and dip your fingers in 2 stroke oil and coat the cyl walls before dropping the cylinders on

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How much oil do I add on a freshly rebuilt motor for an 08 VX110?
    By macGruber in forum Yamaha PWC Performance (4-stroke)
    Replies: 0
    Last Post: 06-14-2014, 10:20 AM
  2. How much oil in a 4-Tec?
    By Bruins in forum 4-Tec Performance
    Replies: 1
    Last Post: 09-18-2007, 09:04 AM
  3. How much oil for the triple bearing mod?
    By rxpblast in forum 4-Tec Performance
    Replies: 3
    Last Post: 01-11-2007, 10:40 PM
  4. How Much Oil
    By JOSE13RT in forum 4-Tec Performance
    Replies: 3
    Last Post: 08-08-2006, 09:40 PM
  5. How much speed will 2+ lbs boost add?
    By Vern in forum 4-Tec Performance
    Replies: 10
    Last Post: 07-20-2006, 07:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •