01-09-2007, 02:18 PM #1
Are the cranks for the 1100 and 1200 the same? I thought the bottom end of these motors were the same, but I see different part #'s on different sites.
01-09-2007, 02:42 PM #2
- Join Date
- Dec 2005
- Beaufort, SC
I thought that the only difference was the front bearing, but that it can be swapped out.
01-09-2007, 03:17 PM #3
That is the difference .the front bearing on the 1200 is a 2 piece, the bearing and a thick washer, where the 1100 has a more desirable large bearing that is the the length of the 1200's bearing and washer combined, I have a 1200 crank in mine with my 1100 front bearing.
01-09-2007, 06:58 PM #4
Are hot rods cranks any good?
01-10-2007, 01:15 PM #5
01-10-2007, 09:09 PM #6
01-10-2007, 09:51 PM #7
Get outta the old school section, you bastage!!!
01-10-2007, 09:52 PM #8
01-11-2007, 07:08 AM #9
Mike here is a picture of my crank it is a 1200 ,notice the far left shows a silver thickwasher or shim, then you can see the darker color bearing, the 1100 has a bearing that is the whole length of those two.
01-11-2007, 09:56 AM #10
Bull I will be completing my 1200 cases soon. If I understand this post correctly I would be better off to get an 1100 front crank bearing to replace my 1200 bearings.
Also any body have any experience with case cooling using the voids in the lower case opposite the inlet? I was told this helps also.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Pistonwash in forum Yamaha PWC Performance (2-stroke)Replies: 21Last Post: 01-05-2008, 01:18 AM
By lawracing in forum 4-Tec PerformanceReplies: 11Last Post: 07-21-2006, 05:23 AM
By mjet in forum Yamaha PWC Performance (2-stroke)Replies: 14Last Post: 04-24-2006, 08:03 PM
By John in forum Yamaha PWC Performance (2-stroke)Replies: 10Last Post: 01-28-2006, 01:38 AM
By idizzy in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 12-03-2005, 11:45 PM