Thread: 4 tec intake (suction side)
02-26-2012, 07:07 PM #1
- Join Date
- Jul 2010
4 tec intake (suction side)
just thought i would throw one out there im constently reading about the kaneflex intake that most people go with but has anyone ever put an aluminum intake in place i didnt know if there was an advantage with the kaneflex over a rigid aluminum
02-26-2012, 07:10 PM #2
I believe the cost factor would come into play at that point.......
02-26-2012, 07:11 PM #3
- Join Date
- Aug 2007
- Sparrows Point, MD (near the Key Bridge)
ive done it on mine, tho its probably a disadvantage because of the heat soak that the pipe receives. But since its compressed and cooled by the IC i guess the effects are minimal. If i were to do it again i'd just go with a kanaflex install.
02-26-2012, 07:30 PM #4
Did mine with 4" alloy and silicone bends. Wasn't easy to get the 4" pipe past the intake man had to put about a 15deg silicone bend half way.
02-26-2012, 07:32 PM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By NISSAN_200 in forum Yamaha PWC Performance (4-stroke)Replies: 2Last Post: 02-18-2012, 09:26 AM
By tempest.runner in forum Towing and TrailersReplies: 1Last Post: 07-10-2011, 03:05 PM
By STSPERFORMANCE in forum 4-Tec PerformanceReplies: 2Last Post: 08-11-2009, 03:25 PM
By Brewer3 in forum Kawasaki PWC Performance (4-stroke)Replies: 5Last Post: 06-02-2007, 04:07 PM
By Mark S in forum 4-Tec PerformanceReplies: 2Last Post: 05-17-2006, 09:08 PM