03-13-2012, 12:12 PM #1
I need help? ET LOW BOOST NEED FPR
Hey I just buy the ET LOW BOOST WHEEL, I need to know if this wheel need the fuel pressure regulator, I have the R&D R2, 8600 RPM, and type 14 I/C. Plz let me know guys.
03-13-2012, 12:52 PM #2
- Join Date
- Mar 2009
03-13-2012, 01:34 PM #3
i think you do need it, its always good to have it that way you can always adjust the gas.
03-13-2012, 01:36 PM #4
According to R&D, an R2 reflash with a C3 wheel does not require the use of the fuel pressure regulator, and the low boost ET wheel is about the same boost as the C3 as far as PSI of boost. So according to R&D, no, but I would recommend one to be safe.
03-13-2012, 02:28 PM #5
- Join Date
- May 2009
You will def need a FPR. I also switched out my r2 to an r3
03-13-2012, 02:31 PM #6
I had r3 with an ET low boost (with all other bolt on mods - i/c etc) and needed a FPR because I was lean. That was only at 8300 rpms
03-13-2012, 03:45 PM #7
03-13-2012, 06:36 PM #8
03-13-2012, 07:31 PM #9
You need an AFR gauge first. That will answer your question.
03-13-2012, 10:03 PM #10
yes thanks, Thursday I'm going to the lake with mike1706 to test my ski with the low boost.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By drodriguez84 in forum Yamaha ClassifiedsReplies: 0Last Post: 03-01-2012, 02:26 PM
By rcapone in forum Yamaha PWC Performance (4-stroke)Replies: 14Last Post: 07-27-2011, 04:48 AM
By zpilot in forum Kawasaki PWC Performance (4-stroke)Replies: 9Last Post: 11-07-2010, 10:05 PM
By stickshift69 in forum 4-Tec PerformanceReplies: 18Last Post: 08-21-2010, 10:25 PM
By lakegastonrxp in forum 4-Tec PerformanceReplies: 3Last Post: 04-29-2010, 04:44 PM