Thread: Trim neutral position of IBR
03-20-2012, 10:34 PM #1
Trim neutral position of IBR
Saw this referred to in other posts. From my Ops. guide (2012 PX):
When in neutral, if the watercraft creeps foward or backward, the IBR system may be trimmed.
If the watercraft is moving fowards, momentarily press the DOWN button.
If the watercraft is moving backwards, momentarily press the UP button.
NOTE: Press the UP/DOWN button repeatedly until proper adjustment of the neutral position is attained and the watercraft stops moving.
03-20-2012, 10:37 PM #2
03-20-2012, 10:55 PM #3
03-21-2012, 12:02 AM #4
03-21-2012, 12:38 AM #5
03-21-2012, 09:53 AM #6
- Join Date
- Jun 2008
- The Hamptons, Long Island, New York
03-21-2012, 12:48 PM #7
So would I. I even tried, but no luck. Mine is way out of whack. Give it a minute and it will back up in Neutral just as fast as it would be if I was holding the brake handle open at idle. BRP has seen the vid and I'm going to give them a chance before I make the vid public. I hope it's something that can be updated. That would be the smart thing to do.
03-21-2012, 02:21 PM #8
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By duudu in forum Yamaha Open DiscussionReplies: 3Last Post: 11-16-2011, 06:50 AM
By wave15stx in forum Yamaha PWC Performance (4-stroke)Replies: 6Last Post: 09-03-2010, 09:05 AM
By mccann316 in forum Polaris Open DiscussionReplies: 7Last Post: 06-09-2010, 11:32 PM
By Jack B in forum Yamaha PWC Performance (4-stroke)Replies: 1Last Post: 05-18-2009, 01:52 PM
By Green Hornet in forum 4-Tec PerformanceReplies: 4Last Post: 12-13-2005, 09:27 AM