Thread: Fuel pump assembly crack!
03-29-2012, 05:50 AM #1
Fuel pump assembly crack!
03-29-2012, 06:29 AM #2
I think the epoxy will hold just fine as long as you use the good stuff. I dont like the playdoh type epoxy, the stuff you mend between your fingers before applying. That stuff is only good for filling the ride plate holes. Get the epoxy GEL, the stuff that comes in the twin seringes (spell check) and is mixed with a stick. I use a little PVC pipe cleaner before applying the GEL, just let the surfaces dry good after using the cleaner before applying the GEL. The stuff can be worked for a few minutes with a wet finger tip, then sanded and painted to hide the blemmish.
03-29-2012, 06:53 AM #3
I used proper 2 part liquid epoxy, well cleaned first.
Just read the packed and it actually says fuel safe so i think it should be good.
Now i just have to finish drilling it without breaking it again!
03-29-2012, 07:48 AM #4
I have one of those off an 05 model if it is the same you can have it.
03-29-2012, 08:11 AM #5
- Join Date
- Nov 2011
- Melbourne - Australia
spewing should hold allright though, maybe even leave the glueing until you install it as it might try and move somewhat once you tighten the bolts up
how did you attach that fitting into the top of it though? as in the fuel pump nipple bit...
03-29-2012, 08:43 AM #6
08+ fuel pump assy are different than the early ones.
03-29-2012, 04:06 PM #7
That big "nut" is a pain to get off!
03-29-2012, 08:01 PM #8
03-29-2012, 08:36 PM #9
No good to me, 05 is different so go ahead!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By bgaidan in forum Polaris ClassifiedsReplies: 4Last Post: 07-02-2015, 10:33 AM
By boostaholic in forum Sea Doo ClassifiedsReplies: 0Last Post: 05-04-2010, 12:47 AM
By neversatisfiedmotorsports in forum Sea Doo ClassifiedsReplies: 1Last Post: 09-16-2009, 04:58 PM
By neversatisfiedmotorsports in forum Sea Doo ClassifiedsReplies: 2Last Post: 08-08-2009, 09:23 AM
By Seadooracer9 in forum Sea Doo ClassifiedsReplies: 0Last Post: 06-22-2009, 09:40 PM