Just thought I post this for anyone looking for mounting ideas on their GTR. There really isn't many places so I figured this one place was good. I made a bracket out of some aluminum I had laying around, already had holes in it so the install was fairly easy. Hardest part was getting the fittings. I looked at alot of peoples on here and couldn't find the same fittings. I took the factory cooling line off the pump area and then cut it to fit the forward part of the strainer and used new heater hose for the rear part. I put the right stuff on all the seals. I haven't water tested it yet, hopefully its good. I also made an emergency bypass fitting in case the strainer gives. All I do then is disconnect the hoses and connect them to the fitting I made.