Thread: Slip on a X sc?
04-07-2012, 05:16 AM #1
Slip on a X sc?
just wanted to know what slip should be on px10 X sc?
about to change oil seal so ill check slip at the same time.....
04-07-2012, 07:45 AM #2
You want somewhere around 120-130 in/lbs.
04-07-2012, 09:08 AM #3
I would pre-load it to about it to about 140-145 inch lbs..that way when she heats up the slip should fall to around 130/135 inch lbs...
04-07-2012, 12:56 PM #4
Lets see, X-Charger = 10 lbs. boost with stock ECU.
12 lb.in. per 1 lb. boost = 120 in.lb.
Add 10 in.lb. for wear in = 130 in.lb TOTAL slip.
However, as Snoman suggested you may wish to add a little up top for the thermal factor. I would rather be a little strong than too weak on the springs and washers.
04-08-2012, 04:18 AM #5
04-08-2012, 04:54 AM #6
Oh and please remind me how to check slip properly again?
(havent wrenched for a while) i know search?? but im lazy!!
04-08-2012, 06:48 AM #7
Mount the supercharger in the mounting tool, hold the gear with the gear tool and using your torque wrench rotate the rear nut clockwise until it slips.
04-08-2012, 05:09 PM #8
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By WBoulton in forum 4-Tec PerformanceReplies: 10Last Post: 12-08-2010, 10:00 AM
By cahickm2 in forum 4-Tec PerformanceReplies: 5Last Post: 07-07-2010, 10:05 PM
By Shark in forum Sea Doo Open DiscussionReplies: 0Last Post: 06-10-2010, 02:33 PM
By ANASTY in forum 4-Tec PerformanceReplies: 13Last Post: 06-07-2010, 06:42 PM
By ERICG1 in forum 4-Tec PerformanceReplies: 17Last Post: 07-15-2009, 01:34 PM